Table of Contents
Advertisement
Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
Install the NETGEAR 802.11g Wireless PCI
Adapter WG311v3.
a. Shut down the PC and remove the
power cord. Insert the WG311v3
Wireless PCI Adapter into an available
PCI slot.
Connect the antenna to the adapter and
position the antenna to the up position.
Reconnect the power cord and reboot
the computer.
b. The Found New Hardware Wizard
displays. Click Next and follow the
prompts to proceed.
c. If prompted, choose the country where
you are located from the list.
d. You will be prompted to enable the
NETGEAR Smart Wireless Settings
Utility configuration utility.
e. Click Yes to accept this option.
If you choose No, you must read the
Windows XP documentation to learn
how to use the Windows XP wireless
network configuration utility.
f.
After the installation completes, click
Finish to close the wizard.
You should see the WG311v3 system tray
icon on the lower right portion of the
Windows task bar.
Windows XP displays a Wireless Network
Connection message.
Basic Setup
Found New Hardware Wizard
Note: If you are prompted with a Windows XP Logo
Testing message, click Continue Anyway.
WG311v3 System Tray Icon
Windows XP Network Connection Alert
2-5
Advertisement
Table of Contents
