NETGEAR WG311v3 Reference Manual page 23

Reference Manual for the NETGEAR 802.11g Wireless PCI Adapter WG311v3
Install the NETGEAR 802.11g Wireless PCI
Adapter WG311v3.
a. Shut down the PC and remove the
power cord. Insert the WG311v3
Wireless PCI Adapter into an available
PCI slot.
b. Reconnect the power cord and reboot
the computer. After a short delay, the
Found New Hardware Wizard
displays.
c. You will be prompted to choose the
country where you are located. Select
your location from the list.
d. Click Next and follow the prompts to
proceed. After the installation
completes, click Finish to close the
wizard.
You should see the WG311v3 system tray
icon on the lower right portion of the
Windows task bar.
Basic Setup
Found New Hardware Wizard
Note: If Windows displays a Digital Signature Not
Found warning, click Yes to continue.
WG311v3 System Tray Icon
2-9