Operation - Zanussi ZGF 640 IT Instruction Booklet

Table of Contents

Operation

Hob burners control knobs

The symbols on the knobs mean that :

there is no gas supply ("off" position)

there is maximum gas supply

there is minimum gas supply

Lighting the burners

For easier lighting, proceed before putting a pan on the pan

support.

To light a burner:

turn the relevant knob anti-clockwise to maximum position (

push it down to ignite the burner.

Upon ignition, keep the knob pushed down about 5 seconds. This

will allow the "thermocouple" (see Fig.1 - letter D) to be heated and

the safety device to be switched off, otherwise the gas supply would

be interrupted.

Then adjust the flame as required.

If the burner accidentally goes out, turn

the control knob to the "off" position

and wait for at least 1 minute before

trying to light the burner again.

If you cannot light the flame even after

several attempts, check the "cap"

(see Fig.1 - letter A) and the"crown"

(see Fig.1 - letter B) are in the correct

position.

To switch off a burner:

To put the flame out, turn the knob to the

symbol (

A A A A A - Burner cap

B B B B B - Burner crown

C C C C C - Ignition electrode

D D D D D - Thermocouple

), then

Fig. 1

Table of Contents