Beko WMB 508311 D User Manual page 25

b. Place a large container at the end of the
hose. Drain the water into the container
by pulling out the plug at the end of the
hose. When the container is full, block
the inlet of the hose by replacing the
plug. After the container is emptied,
repeat the above procedure to drain the
water in the machine completely.
c. When draining of water is finished, close
the end by the plug again and fix the
hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product
does not have an emergency draining hose:
a. Place a large container in front of the filter
to catch water from the filter.
b. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing water
into the container you have placed in
front of the filter. Always keep a piece of
cloth handy to absorb any spilled water.
c. When the water inside the machine is
finished, take out the filter completely by
turning it.
4. Clean any residues inside the filter as
well as fibers, if any, around the pump
impeller region.
5. Install the filter.
A If your product has a water jet feature,
be sure to fit the filter into its housing in
the pump. Never force the filter while
installing it into its housing. Seat the filter
into its place completely. Otherwise,
water may leak from the filter cap.
6. If the filter cap is composed of two
pieces, close the filter cap by pressing on
the tab. If it is one piece, seat the tabs in
the lower part into their places first, and
then press the upper part to close.
25
EN