Table of Contents
Advertisement
en-us Basic settings
Basic settings
14 Basic settings
You can configure the basic settings for your appliance to meet your needs.
Basic settings
14.1 Overview of the basic settings
The basic settings depend on the features of your appliance.
Basic setting
Time setting
Time format
Time display
Sprache/Language
Water hardness
Rinse aid disp.
Sensor setting
Extra Dry
Eco forecast
Emotion Light™
Infolight®
Start program
Tone volume
Button volume
1
Factory setting (may vary according to model)
24
Selection
00:00 - 24:00
12 h
24 h
1
In hours
1
Time
See selection on the
appliance.
0 - 62
0 - 8
1
0 - 6
5
1
1
Standard
Sensitive
Very sensitive
on
off
1
on
off
1
off
On via main switch
1
On when opening door
1
on
off
1
Auto 130-150°F
Prog. last selected
Scale with multiple levels.
Scale with multiple levels
Description
Set the current time.
The setting depends on the time format selected.
Set the time format.
Set the time display for the end of the wash cycle.
"Finish in" shows the remaining time the wash cycle still
has to run, e.g. 3h 25min.
"Finish at" shows the time when the wash cycle will end,
e.g. 3:20pm.
Select the menu language.
Set the water hardness.
→ "Overview of water hardness settings", Page 16
Set or switch off the amount of rinse aid to be dispensed.
→ "Setting the amount of rinse aid", Page 18
Set the water sensor for identifying soiling.
→ "Sensors", Page 6
Switch "Extra Dry" on or off for each operation.
The temperature is increased during the final rinse for a
better drying result. This may increase the run time slightly.
Please take care with delicate dishware.
Switch EcoCheck on or off.
When selecting the wash cycle, the average water and
energy consumption is briefly shown on the display.
Switch the interior lighting of the appliance on or off.
When the appliance door is opened, the interior lighting
switches off automatically after 10 minutes.
Switch "Infolight®" on or off.
While the wash cycle is running, a spot of light is projected
onto the floor below the appliance door. This light will not
be visible if the appliance is installed at eye level with the
cabinet front fitted flush. If the appliance door is not
completely closed, the spot of light will flash. The wash
cycle has ended when the spot of light is no longer visible
on the floor.
Set a default program for when the appliance is switched
on.
Set the signal volume at the end of a wash cycle.
Level 0 switches the signal tones off.
Set the button volume during operation.
Level 0 switches the button tones off.
Advertisement
Table of Contents
