Changing To A 30- Or G0-Minute Timing Camm - Maytag MDE18MNAY Installation Instructions Manual

CHANGING TO A 30- OR 60-MINUTE TIMING CAM
(on some models)
5. Place new cam (hub side down) over clock shaft. Line up flat
AWARNING side of shaft with flat side of cam hole. Check that drive lug is in
place.
Electrical Shock Hazard
Drive Lug
Disconnect power before making cam changes.
Failure to follow these instructions can result in death
or electrical shock.
Coin-slide models: You can install the 30-minute or 60-minute
timing cam (shipped with dryer) as follows:
1. Unplug dryer or disconnect power.
2. Unlock meter case.
3. Turn the timing cam by hand until the V-shaped notch lines up
below the ratchet tooth.
V-Shaped Ratchet
7. Press cam down in place on clock shaft. Make sure that
V-shaped notch clears the ratchet tooth.
4, Insert a narrow, flat-blade screwdriver under the timing cam near
the clock shaft. Genily lift cam straight up and off shaft, making
sure that the V-shaped notch clears the ratchet tooth.
8. Close and lock the meter case.
9. Plug in dryer or reconnect power.
25