Maytag MDE18MNAY Installation Instructions Manual page 19

ELECTRIC DRYER ELECTRICAL CONNECTIONS (FOR U.S.A. ONLY)
Connection Options
Power Cord Direct Wire 4°
4-wire receptacle (NEMA Type 14-30R) 4-wire direct 5 ran)
eo
Li
—
(lap tm
3-wire receptacle (NEMA Type 10-30R) 3-wire direct
oa"
9 mm)
Connecting 4-Wire Connection: Power Supply Cord
IMPORTANT: A 4-wire connection is required for mobile
homes and where local codes do not permit the use of 3-wire
connections.
Standard Power Supply Cord Connectors Connecting Direct Wire Ground
3. Connect ground wire (green or bare) (E) of power supply cord
ye 0x8) under green external ground conductor screw (C). Tighten
Flanged Spade Connector Ring Connector SCTOW.
Connecting Neutral Ground and Neutral Wires
1. Remove center terminal block screw (A) and the neutral
ground wire (B) by removing the green external ground
conductor screw (C).
HBC
Connecting Remaining Wires
4, Connect remaining wires under outer terminal block screws
(F). Tighten screws. Finally, reinstall terminal block to dryer rear
panel. Secure cover with hold-down screw.
2. Connect neutral ground wire (B) and neutral wire (white or
center wire) (D) of power supply cord under center terminal
block screw (A). Tighten screw.
19