Advertisement
Only run the soak program with half loads.
Options cannot be used with the soak program.
The ENERSAVE option cannot be used with soak, ultra clean, or any programs
which do not include the final drying stage.
*
Standard programme under EN 50242. The ENERSAVE option must be
enabled.
**
See information sheet provided
IEC/DIN reference programme. The ENERSAVE option must be enabled.
***
Reference program for laboratories: Detergent: 20g in the dispenser + 10g in
****
the door or tablet. Configuration: see photo in "Using the baskets".
(1)
Program consumption and duration figures have been measured in
accordance with the EN 50242 standard. Values may vary depending on
intake water and room temperatures and the type and quantity of dishes
loaded.
(2)
1 or 2 cold rinses depending on the model.
REFERENCES for the ENERGY LABEL supplied with the dishwasher:
-
Annual energy consumption is based on 280 standard wash cycles with cold
water and consumption of low-energy operating modes. Actual consumption
depends on the way in which the appliance is used.
-
Water consumption is based on 280 standard wash cycles. Actual
consumption depends on the way in which the appliance is used.
-
Information refers to the EN 50242 STANDARD programme (identified in the
programmes table), which is the most effective in terms of combined energy
and water consumption. The programme is recommended for dishes with a
normal level of dirt.
-
Energy consumption in "sleep" mode = 0.02 W.
-
Energy consumption in "on" mode = 0,8 W.
-
Drying efficiency class on a scale from "G" (minimum efficiency) to "A"
(maximum efficiency).
10
User instructions
NOTES AND REFERENCES
Advertisement
