KTM 250 SX-F EU 2014 Setup Instructions page 8

3 WORK
3.1 Raising the motorcycle with the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
3.2 Removing the motorcycle from the lift stand
Note
Danger of damage The parked vehicle may roll away or fall over.
–
Always place the vehicle on a firm and even surface.
3.3 Installing the front wheel
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
–
Raise the motorcycle at the frame underneath the engine.
The wheels must no longer touch the ground.
–
Secure the motorcycle against falling over.
Lift stand (54829055000)
C00408-01
(All SX‑F models)
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, insert plug-in stand
spindle.
C00403-10
(XC‑F)
–
Remove the motorcycle from the lift stand.
–
Remove the lift stand.
–
To park the motorcycle, press side stand
lean the motorcycle on it.
C00401-10
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change the wheel bearing.
–
Clean and grease the shaft seal rings
Long-life grease (
–
Insert the spacers.
–
Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
101745-11
Info
Remove the plug-in stand before starting on a trip.
Info
When you are riding, the side stand must be folded up and secured with
the rubber band.
1
p. 14)
into the left side of the wheel
1
to the ground with your foot and
1
and contact surface of the spacers.
A
6