Table of Contents
Advertisement
them when the appliance is installed.
3. The power supply cord shall not contact the hot parts of the appliance.
4. If the power supply cord is damaged, this cord shall be replaced by the manufacturer or its
service agent or an equally qualified personnel to prevent a hazardous situation.
5. Never wash the product by spraying or pouring water on it! There is a risk of electrocution.
6. WARNING: To avoid electric shock, ensure that the device circuit is open before changing
the lamp.
7. WARNING: Cut off all supply circuit connections before accessing the terminals.
8. WARNING: If the surface is cracked, turn off the appliance to avoid risk of electric shock.
9. Do not use cut or damaged cords or extension cords other than the original cord.
10. Make sure that there is no liquid or humidity in the outlet where the product cord is
connected.
11. The rear surface of the oven also heats up when the oven is operated. Electrical
connections shall not touch the rear surface, otherwise the connections may be damaged.
12. Do not tighten the connecting cables to the oven door and do not run them over hot
surfaces. If the cord melts, this may cause the oven to short circuit and even a fire.
13. Do not use steam cleaners for cleaning the appliance, otherwise electric shock may occur.
14. Fixed connections shall be connected to a power supply enabling omnipolar disconnection.
For appliances with over voltage category below III, disconnection device shall be connected to
fixed power supply according to wiring code.
Gas Safety
1. This appliance is not connected to burning products evacuation apparatus. This appliance
must be connected and installed according to the installation regulations in force. Conditions
regarding ventilation must be considered.
2. When a gas cooking appliance is used, humidity, heat and burning products are generated
in the room. First of all, make sure the kitchen is well ventilated when operating the appliance
and maintain natural ventilation openings or install a mechanical ventilation equipment.
3. After using the appliance heavily for an extended period of time, additional ventilation may
be required. For example open a window or adjust a higher speed for mechanical ventilation, if
any.
4. This appliance must be used only in well ventilated locations in accordance with the
regulations in force. Please read the manual before installing or using this product.
5. Before positioning the appliance, make sure local network conditions (gas type and gas
pressure) meets appliance requirements.
6. The mechanism cannot be run for longer than 15 seconds. If the burner is not on after 15
seconds, stop the mechanism and wait for at least one minute before trying to ignite the burner
again.
7. All kinds of operations to be performed on gas installation must be performed by authorized
and competent people.
8.
This appliance is adjusted for natural gas (NG). I
f you have to use your product with a
different gas type (Universal LPG), you have to apply to authorized service for the conversion.
9. For proper operation, hood, gas pipe and clamp should be replaced periodically according to
manufacturer recommendations and when required.
10. Gas should burn well in gas products. Well burning gas can be understood from blue flame
and continuous burning. If gas does not burn sufficiently, carbon monoxide (CO) can be
generated. Carbon monoxide is a colourless, odourless and very toxic gas; even small
amounts have lethal effect.
11. Ask your local gas supplies about the phone numbers for emergencies related to gas and
the measures to be taken upon gas odour is detected.
4
Advertisement
Table of Contents
