Table of Contents
Advertisement
Quick Links
RL1 Liferaft lights & RB2 Battery pack
also applies to RL1 (RFD/DSB) & RB2 (RFD/DSB)
Installation and Maintenance Instructions
Description
RL1 The RL1 is an internal light for liferafts to provide adequate light for reading inside a covered raft,
for a minimum of 12 hours. The unit is fully sealed and watertight, and comprises a plastic dome
and incandescent lamp. A cable with moulded plug is provided to connect to the socket of a RB2
battery pack.
RB2 Each battery pack comprises a single lithium cell in a sealed moulded housing including a switch;
this permits both automatic and manual operation. The battery is protected against damaging
currents and short circuits by a fuse.
58-7010-PAT Issue 11 (C6495)
Advertisement
Table of Contents
Related Manuals for Daniamant RL1
Summary of Contents for Daniamant RL1
- Page 1 Installation and Maintenance Instructions Description RL1 The RL1 is an internal light for liferafts to provide adequate light for reading inside a covered raft, for a minimum of 12 hours. The unit is fully sealed and watertight, and comprises a plastic dome and incandescent lamp.
- Page 2 Installation Light The base of the RL1 has two fixing slots. The unit can be attached to the raft by: – Being stitched to raft fabric, then mounted by adhesive inside the apex of the canopy. – By a fixing plate, as shown on Page 3.
- Page 3 Battery disposal Dispose of used batteries in accordance with local regulations. This should be done through an approved environmental disposal agent. Light and battery pack Method of attaching light Suggested attachment points to liferaft (alter- native positions may be used)
- Page 4 To ensure compliance with the WEEE and Battery Regulations, the Survivor Lo- cation Lights placed on the market in the UK or Denmark should be returned to Daniamant in the UK or Denmark, or deposited in your nearest WEEE Designated Collection Facility, operated by your Local Authority.
- Page 5 RL4 Liferaft light & RB2 Battery pack also applies to RL4 (RFD/DSB) & RB2 (RFD/DSB) Installation and Maintenance Instructions Description RL4 The RL4 is a high intensity flashing light for mounting externally on liferafts. The unit is fully sealed and watertight, and comprises a plastic dome, incandescent lamp and electronic circuit. Two cables with moulded plugs are provided to connect to the sockets of two RB2 battery packs.
- Page 6 Installation Light The base of the RL4 has two fixing slots. The unit can be attached to the raft by: – Being stitched to raft fabric, then mounted by adhesive at the apex of the canopy. – By a fixing plate, as shown in the attached drawing. Battery leads should be stitched into a seam during raft manufacture.
- Page 7 Health and Safety information Daniamant lithium-powered marine safety light systems have a design life of 5 years. The batteries are hermetically sealed pressurised primary Lithium/Sulphur Dioxide cells, and as supplied are electrically protected by diodes and a fuse, and are environmentally protected by a moulded plastic housing. In this condition the units pose no definable hazard to health.
- Page 8 To ensure compliance with the WEEE and Battery Regulations, the Survivor Lo- cation Lights placed on the market in the UK or Denmark should be returned to Daniamant in the UK or Denmark, or deposited in your nearest WEEE Designated Collection Facility, operated by your Local Authority.
Need help?
Do you have a question about the RL1 and is the answer not in the manual?
Questions and answers