Table of Contents
Advertisement
7
The Dogtrace d-balls remote is designed to work with 4 d-balls droppers or d-ball UP
throwing machines. A signal can be sent to these devices for an sound alert or to release/
throw the ball.
8
Commands for balls ejection are sent from the transmission unit to the ball dropper on radio
waves. Radio wave propagation is influenced by many factors. The reach of this device is
approximately 250 m at common circumstances (depending on geographical conditions
and surroundings).
Follow the instructions below to get the best results with this device:
To get the best connection, hold the remote controller in your hand not covering its front
part (the antenna is installed in this part).
The reach is increased by holding the remote controller with your hand outstretched in
front of you.
Check the battery status in the remote controller as well as in the ball dropper before
using the set. Replace the batteries if necessary.
Battery performance decreases moderately at temperatures below 0 °C. If possible, keep
the remote controller warm in your pocket and take it out only when using.
9
Don't put the remote controller close to objects sensitive to magnetic field to avoid
causing permanent damage to them.
Don't expose the d-balls set to high temperatures.
It is necessary to replace the batteries every two years, even in case the set has not been
in use for a longer period of time. Don't leave discharged batteries in the device to avoid
potential damage.
The set is designed to be used with four balls maximally. Don't use any extenders to
increase the capacity. It could cause damage to the device.
Use only balls delivered with the set or recommended by the manufacturer. Using different
balls than recommended can cause damage to the device.
8
HOW TO USE THE REMOTE CONTROLLER
FOR THE BEST RESULTS
USER INSTRUCTIONS
Advertisement
Table of Contents
