Battery Installation And Replacement - Dog trace d-balls Manual

4

BATTERY INSTALLATION AND REPLACEMENT

Installation (replacement) of the battery in the ball dropper
Remove the screw from the ball dropper battery space cover with a cross-head screwdriver.
Take the battery holder out carefully. Insert 4 LR6 AA 1,5V batteries. Mind the polarity
marked on the battery holder.
Before putting the battery space cover back to its place make sure that the battery holder
is seated in the battery space correctly. Tighten the screw on the battery space cover using
adequate force.
Battery space cover
Checking the battery status
Look at the indicator light on the front panel of the ball dropper to check the battery status:
The battery is fully charged: the LED indicator blinks slowly in green in on-state.
The battery is weak: the LED indicator blinks in red in on-state. Prepare 4 spare LR6 AA 1.5
V batteries and follow the previous paragraph Installation of the battery in the ball
dropper.
TIP: The device can also be operated using LR6 rechargeable batteries.
Installation (replacement) of the battery in the
remote controller
Unscrew the battery space cover screw on the back side
of the remote controller and litt the cover carefully. Insert
a new 3V CR2 battery. Mind the polarity marked on the
battery cover (see the picture). Put the cover back and
tighten the screw using adequate force.
When the battery gets weaker, the remote controller
performance (radio signal coverage) decreases. The
battery needs to be replaced. Discharged battery is
indicated by red LED diode which is lit up by pressing any
button on the remote controller. Prepare a spare battery
and follow the instruction above for replacing batteries in the remote controller.
TIP: You can remove the batteries more easily using a small screwdriver inserting it
carefully under the edge of the battery.
Make sure the remote controller is working correctly. By pressing any button, the green
LED diode lights up.
6
Battery holder
Battery compartment