Table of Contents
Advertisement
5
Turning on: Place the lower part of the remote
controller to the marked arrow (see the picture).
The ball dropper indicator blinks in red (The ball
dropper is recognised). Remove the remote
controller when the LED diode lights up in red
permanently. The diode starts blinking in green
indicating the ball dropper is ready for use.
Turning off: Place the lower part of the remote
controller to the marked arrow (see the picture)
again. The receiver indicator lights up in red.
Remove the remote controller. The red LED
diode goes out. The ball dropper is turned off.
To prolong the battery lifetime, the ball dropper is
always to be turned off after training. If the ball
dropper is not used for a longer period of time,
removing batteries is recommended.
6
PROGRAMMING (PAIRING) OF THE REMOTE
Every remote controller has its own RF operational code. Programming of the remote
controller with the ball dropper will be performed during the first use of the Dogtrace
d-balls set or with a new remote controller or ball dropper (in case they get lost). This
operation enables you to match your remote controller with the delivered ball dropper.
IMPORTANT: Before programming (pairing) is started, make sure no one else is using
d-balls ball dropper or another Dogtrace product close to you. Your ball dropper could
randomly receive a code from another remote controller and set itself to it. If this happens,
program your ball dropper once again using your remote controller.
If you have inserted balls into the container, replace them.
Place the lower part of the switched-off remote controller to the arrow marked on the ball
dropper (see the picture on page 7). The red LED diode blinks, the green LED diode lights
up for 3 seconds. Then the red as well as the greed LED diode starts blinking. The ball
dropper is ready for pairing. Now move the remote control away and press the sound
button 1 to 4 on the remote control keypad to control the ball dropper. The ball dropper
should beep when the sound button is pressed.
Use the same procedure for pairing more ball droppers.
TURNING ON / OFF
CONTROLLER AND THE RECEIVER
Position when switching on/off the ball
dropper and when pairing the transmitter
with the ball dropper
7
Advertisement
Table of Contents
