Advertisement
Quick Links
Advertisement
Related Manuals for Petsafe NanoBark
Summary of Contents for Petsafe NanoBark
- Page 1 Get Started!
-
Page 2: Before We Start
NanoBark ™ Collar for Small Dogs Before we start: We know that teaching your dog when not to bark can be challenging. Keep these things in mind as you begin training: Your dog This bark collar has a unique sensor that provides the most reliable bark detection available. -
Page 3: What You Have
What you have: Test light tool Bark collar Charger How it works: The bark collar starts learning your dog’s bark pattern after the first two to three barks and automatically adjusts its correction for your dog’s personality and barking habits. There are 10 levels of static correction. - Page 4 Charge the bark collar Connect the charger to the magnetic charging port on the back of the collar and then plug it in. Leave the bark collar plugged in until it is fully charged; this will take about 2 hours. The LED on the bottom of the bark collar will glow green when the collar is charging and will turn off when the bark collar is fully charged.
- Page 5 Fit the bark collar See our collar fitting video With your dog standing comfortably, place the bark collar high around his neck, close to his ears. The contact points should be centered directly under your dog’s chin, touching his skin. If your dog has long hair, it may be necessary to trim (not shave) the hair around the contact points to make sure that contact is consistent.
- Page 6 Turn the bark collar on Turn the bark collar on by pressing and holding the power button until the bark collar beeps low to high and the LED on the bottom of the collar flashes green. The LED will flash every 5 seconds (green or red) to indicate battery charge.
- Page 7 Use the bark collar Stay with your dog the first few times he wears the bark collar. He may initially be startled by the correction and bark more. If this happens, speak to your dog in a calm, reassuring voice until he relaxes. He’ll soon realize that the correction stops when he is quiet.
- Page 8 If your dog barks and the bark collar doesn’t seem to be correcting him: Recheck The bark sensor uses vibration to detect your dog’s bark. This is what prevents the bark collar from correcting your dog for the fit. other dogs’ barking or loud noises nearby. If the bark collar is too loose, the bark sensor will not be able to detect the vibration of your dog’s vocal cords and the bark collar will not issue a correction.
- Page 9 Test the If you are certain you have fit the bark collar properly to your dog but it still doesn’t seem to be working, complete the bark collar. following steps to test the bark collar. You will need the test light tool (see page 3).
- Page 10 Remember these important tips when using your bark collar: Be consistent. Use the bark collar in every situation in which you want your dog to be quiet. If your dog realizes he is not wearing his bark collar, he may resume his bad barking habits and his learning will be delayed.
- Page 11 Turn down the noise. Turn up the joy.
-
Page 12: We're Here To Help
NanoBark ™ Collar for Small Dogs We’re here to help! For questions or additional tips: support.petsafe.com ©2023 Radio Systems Corporation | Model: PBC00-17758 | L400-2588 For important safety instructions, please see the customer care guide.
Need help?
Do you have a question about the NanoBark and is the answer not in the manual?
Questions and answers
WHITE LIGHT STAYS ON, DOES NOT BEEP, DOES NOT GO GREEN