Table of Contents
Advertisement
Malfunction
Drying time is too long.
Water is leaking.
Laundry is too damp.
Cause and troubleshooting
Heat exchanger is contaminated.
→ "Opening the bottom unit", page 36 .
1.
Clean heat exchanger.
2.
→ "Clean the bottom unit", page 36
→ "Close bottom unit", page 38 .
3.
The device is not properly leveled.
→ "Adjusting the device", Page 16
▶
The seal of the heat exchanger cover is
contaminated.
Clean the seal of the heat exchanger cover.
▶
→ "Clean the filter system of the base unit", page
33
Water drain hose is not connected correctly.
Make sure the water drain hose is connected
▶
correctly.
→
"Connecting the water drain hose", page 14
Heat exchanger cover lever not closed correctly.
Make sure the heat exchanger cover handle is closed
▶
correctly.
→ "Close bottom unit", page 38
Unsuitable program set for the textile type.
Set a time program for final drying.
▶
→ "Programs", page 26
Power supply has failed.
Check whether the interior lighting or other
▶
appliances are functioning.
The loading quantity is too high.
Please note the maximum loading quantity of the
▶
→ "Programs", page 26 .
Warm laundry feels damper at the end of the
program than it actually is.
Remove the laundry from the drum immediately after
1.
drying.
Spread the items out to let them cool.
2.
Inappropriate drying target set.
→
"Change drying target", page 25 .
▶
Drying target not adjusted.
→ "Adjust drying target", Page 25 .
▶
TroubleshootingNL
43
Advertisement
Table of Contents
