NLTroubleshooting
Malfunction
Condensation water in it
condensation water tank
voir, although the
water drain hose is
locks.
Program does not start.
The program duration
changes during
drying.
Pump noise.
Buzzing sound.
Drying time is too long.
42
Cause and troubleshooting
The device uses condensation water for automatic self-
cleaning.
No error - no action necessary.
▶
Water drain hose is not connected correctly.
Make sure the water drain hose is connected
▶
correctly.
→
"Connecting the water drain hose", page 14
Child protection is activated.
→ "Deactivate child lock", page 35
▶
Start/Pausewas not pressed.
Press
Start/Pause.
▶
No program set.
→ "Set program", page 30 .
1.
→ "Starting the program", Page 31 .
2.
The program sequence is optimized electronically. This
may lead to changes in the program duration.
No error - no action necessary.
▶
Condensation water pump active.
No error - normal operating noise.
▶
Compressor venting active.
No error - normal operating noise.
▶
The filter in the bottom unit is contaminated.
→ "Clean the filter system of the base unit", page
▶
33
Fluff filter is contaminated.
→ "Clean the fluff filter", page 31
▶
Ambient temperature is higher than 30°C.
Make sure the ambient temperature is below 30°C.
▶
Ambient temperature is lower than 15°C.
Make sure the ambient temperature is above 15°C.
▶
Insufficient air circulation at the installation location of
the device.
▶ Ventilate the installation location of the device.
Air inlet of the device is blocked.
Make sure that the air inlet of the device is kept
▶
clear.