Table of Contents
Advertisement
I
releases tape. Tape stops moving.
I
the rewind direction.
I
I
I
I
Reference and Speed Controls
2.2.2.
I
Lo d
roll of t pe.
Turn the REFERENCE switch to VAR.
I
Turn the SPEED switch to HI.
Press the TORQUE LIMIT switch (10 inch model).
Put the tr nsport into PLAY Mode.
I
Press nd hold the TVI switch.
I
I
I
Put the tr nsport into PLAY mode.
Press and hold the TVI switch.
I
I
Repe t the bove procedure for LO speed.
Page 2-8
Allow the end of the t pe to spill over the right
side of the tape tr nsport.
Press the PLAY button.
RWD light goes OFF. Both STO
and
LAY
lights come ON. Tape stops. STO
light goes
OFF. Tape lifter goes to its recessed position.
Capstan pressure roller clamps tape to the
capstan. Tape smoothly accelerates to selected
play speed.
Allow t pe to rewind completely.
As soon as the tape pulls away from the takeup
reel, it comes out of the tape sensor slot. All
transport lights go OFF. Mechanical brakes
come ON. RTZ Display freezes at end of tape
position.
Thre d the tape
cross the he ds, through the
c pst n ssembly, but NOT through the t pe sen
sor slot.
Press the EDIT button.
EDIT light comes ON. Capstan pinch roller pulls
tape against the capstan. Tape spills over the
right side of the tape transport. The takeup reel
is not activated. (This reel may creep slowly.)
Rethre d the t pe through the t pe sensor slot
nd round the t keup reel.
EDIT light goes OFF. Reels turn at idle speed
and take up any slack tape.
Press the EDIT button.
EDIT light comes ON. Reel stops.
Pull t pe out of the t pe sensor nd to the right.
EDIT light stays ON. Reel motors give no
resistance to tape movement, and turn easily in
either direction.
Slowly rot te the VAR potentiometer.
Note the speed variation between minimum and
maximum position of the potentimeter. The
speed range will be from -20% to +20% of the
high speed mode of your machine.
Turn the SPEED switch to MED.
The transport goes into STO
mode.
Repl ce t pe in t pe sensor slot.
EDIT light goes OFF. Reels turn at idle speed
and take up any slack in tape.
Press the LO TORQUE LIMIT switch (14 inch
model).
Slowly rot te the VAR potentiometer.
The speed variation will be ±20% of the MED
speed of your machine.
Press the RECORD button. (On the bro dc st
tr nsport press both PLAY and RECORD)
RECORD light comes ON. ( LAY light is still
ON.)
Press the RWD button.
RECORD light and
LAY light go OFF. RWD
light comes ON. Capstan pinch roller releases
tape. Tape stops. Tape lifters lift tape away
from heads. Tape accelerates in rewind mode.
CAUTION:
The following step will result in erasure of
any material which has been recorded on the
tape.
NOTE:
Transport is in Record mode. However, on
the JH-110B decks ONLY channels which
have been put into Record-Ready will make a
recording.
Press the STOP button.
EDIT
light
goes
OFF.
Capstan
pressure
Advertisement
Table of Contents
