Operating Rocedures; Transport Motion Controls; Mastering Audio Controls And Indicators - MCi JH-110 Series User Manual

2.2 Operating rocedures
I
2.2.1 Transport Motion Controls
I
JH-110M Only
I
I
I
EQ
o
>
+l
HI S EED
I
o
I
MED S EED
LO S EED
o
I
TW27B-I9
I
Figure 2-9 Mastering Audio Controls and Indicators
I
I
Remove the c rd. Lo d roll of t pe.
I
I
I
I
Page 2-6
STO light is ON. Reels wind up loose tape and
establish idle tension.
> — Adjusts low end equalization for medium
speed (15 ips).
OUT — Selects repro head output for meter
display.
Turn the Power Switch ON. (Loc ted inside the
well t the bottom of the c binet.)
Meter lights come ON. All transport function
lights are OFF.
Press the FWD button.
STO light goes OFF. FWD light comes ON.
Tape lifters lift tape away from the heads. The
tape accelerates to a fast movement in the FWD
direction.
in 3 seconds. The speed need not be identical
for the two reels.
MED SPEED
< — Adjusts high end equalization for medium
speed (15 ips).
LO SPEED
< — Adjusts high end equalization for low
speed (7-1/2 ips).
vu
-io 7
-zo y-
Insert n op que c rd into the T pe Sensor Slot.
The yellow light comes ON under the STO but ­
ton. The takeup reel starts turning
counterclockwise. The supply reel starts turn ­
ing clockwise. The speed of rotation for both
reels is approximately 20 rpm — or about 1 turn
Phone
Jack for low impedance headphones, disables
monitor speaker output.
HI SPEED
< — Adjusts high end equalization for high
speed (30 ips).
vu
+2
*V.+3
-3 -2 -I 0
r . f i
40
> — Adjusts low end equalization for low
speed (7-1/2 ips).
> — Adjusts low end equalization for high
speed (30 ips).