Table of Contents
Advertisement
I
I
TORQUE LIMIT
◄ ------ MVC
I
)
RECORD
EDIT
RWD
FWD
PLAY
STOP
I
TW27B-2O
I
Figure 2-10
Transport Motion Controls
2
I
I
I
I
I
I
Set the MVC Joystick to some intermedi te for-
I
I
Page 2-7
->
)
Touch (do NOT move) the MVC Joy stick.
Tape starts in the same direction and at the
same speed which was set when the Joystick
was last used.
Slowly move the MVC Joystick to the left.
Tape comes to a stop and then moves in the
reverse direction. Speed of the movement is
directly related to the angle of the Joystick.
Slowly move the MVC (M nu l Velocity Control)
Joystick to the right.
LED located in the joystick comes ON. Tape
moves forward. (Speed of movement is directly
related to the angle of the joystick.)
Rele se the MVC Joystick.
MCV LED turns OFF. Tape stops.
Press the STOP button.
RWD light goes OFF. STO
light comes ON.
Tape lifters go to their recessed position.
Press ny (except EDIT or REC) tr nsport control
button.
Machine drops out of latched MVC mode and
enters the mode selected. MVC LED goes OFF.
w rd speed — then rele se it.
MVC LED turns OFF. Tape stops.
Press the STOP button.
STO
light comes ON. Tape stops.
Press the PLAY button.
STO
light goes OFF.
LAY light comes ON.
Capstan pressure roller clamps tape to the
capstan. Tape moves at selected play speed.
Press the RWD button.
LAY light goes OFF. RWD light comes ON.
Capstan pinch roller releases tape. Tape lifters
lift tape away from heads. Tape accelerates in
Press the FWD button.
STO
light goes OFF. FWD light comes ON.
Tape lifters come forward. Tape accelerates to
full speed forward.
NOTE:
The Joystick may not work if good hand con
tact is not made to the surface of the tape
transport. Contact may be made with either
hand.
Press the RWD button.
FWD light goes OFF. RWD light comes ON.
Tape
slows
smoothly
and
reverses
direction,then accelerates in a rewind direction.
Touch (do NOT move) the MVC Joystick.
MVC LED comes ON. Tape slows to the in
termediate speed already established by the
position of the MVC Joystick.
Rele se the MVC Joystick.
Nothing changes. Tape continues to move.
MVC LED stays ON. This is known as Latching
MVC Mode.
Advertisement
Table of Contents
