Jh-110M Fast Motion Limit Control - MCi JH-110 Series User Manual

I
I
SECTION 2
I
OPERATING PROCEDURES
I
I
I
I
I
2.
Controls & Indicators
Control/lndicator
I
I
I
I
FAST MOTION LIMIT
I
I
MAX MIN
TW27B-I6
I
I
I
Page 2-1
Figure 2-2
JH-110M Fast Motion Limit Control
This section lists all the control switches and
indicators of the tape transport and the audio
electronics. Several examples of the use of these
controls follow these lists. These examples can
be used to familiarize yourself with the operation
of the tape recorder or as a post installation check
out procedure to insure proper operation. For
detailed maintenance and alignment procedures,
consult Section 7 of the Technical Manual.
speed. To record, RECORD READY must also
be selected at the audio panel.
When pressed with tape in the tape load sen ­
sor, disables the tape tension system. Tape
then moves freely by hand. Tension is restored
when tape is replaced in tape load sensor or
EDIT, is pressed a second time.
STOP
Cancels previously selected motion command
and stops tape.
RWD
Rewinds tape onto supply reel at fast speed.
Cancels previously selected motion command
(i.e. FWD, LAY, or RECORD).
FWD
Winds tape onto take-up reel at fast speed.
Cancels previously selected motion command.
EDIT
When pressed with tape out of the tape load
sensor, unspools tape from supply reel without
winding it onto the take-up reel. Tape spills off
right side of deck for editing and stops when
STO is pressed.
FAST MOTION LIMIT (110M Only)
Adjusts the maximum limit of the fast forward
and rewind speeds, as well as maximum RTZ
speed.
RECORD
When pressed with LAY button, or when in
play mode, enables recording at selected
PLAY
Initiates playback at the selected speed and
cancels previous motion command
(RWD,FWD,STO ,or RECORD). layback
source is selected at the audio panel.