Connecting; Disconnecting - Toshiba Satellite M40 User Manual

3. If you are transferring data through an IEEE1394 hub, do not connect or
disconnect other devices from the hub during data transfer. There is a
likelihood that data will be damaged. Connect all devices to the hub
before you turn on the computer's power.
4. You may not use any copyrighted video or music data copied from a
video camera except for your personal enjoyment.
5. If you connect/disconnect an i.LINK device to/from another i.LINK
device that is currently exchanging data with the computer, data frames
might be dropped.
6. Make sure data transfer has ended or turn off the computer, before you:
■
■

Connecting

1. Make sure the connectors are properly aligned and plug the i.LINK
(IEEE1394) cable into the computer.
2. Plug the other end of the cable into the device.
Note the following when you use i.LINK:
■
■
■
■
■
■

Disconnecting

1. Open the Safety Remove Hardware icon on the Task Bar.
2. Point to i.LINK (IEEE1394) device and click.
3. Disconnect the cable from the computer then from the i.LINK device.
Refer also to the documentation that came with your i.LINK device.
User's Manual
Connect/disconnect an i.LINK device to/from the computer.
Connect/disconnect an i.LINK device to/from another i.LINK device
that is connected to the computer.
You may need to install drivers for your i.LINK devices.
Not all i.LINK devices have been tested. Therefore, compatibility
with all i.LINK devices cannot be guaranteed.
Use S100, S200 or S400 cables no longer than three meters.
Some devices might not support Standby Mode or automatic off
functions.
Do not connect or disconnect an i.LINK device while it is using an
application or when the computer is automatically shutting it down to
save power. Data might be destroyed.
When multiple IEEE1394 devices are connected to a PC, the
devices may not correctly be identified. This problem may occur
®
when Windows XP is restarted while the devices are connected or
when the power to the IEEE1394 devices is turned on before the PC
is turned on. If it occurs, disconnect the IEEE1394 cables and then
reconnect them.
Optional Devices
8-13