Table of Contents
Advertisement
4.2 Cleaning
Dust build up reduces light output performance and can cause overheating. This can
lead to reduction of the light source's life. We recommend frequent cleaning of the
fixture. When cleaning, please use a moist, lint-free cloth. Never use alcohol or
solvents.
4.3 Lamp replacement
The moving head is equipped with an Osram 230W lam. Follow the procedure below
to safely change the lamp.
Figure 1
1) Turn off the product and disconnect it from power. Wait at least 15 minutes for
lamp to cool down.
2) Use 1/4 turn screw driver to remove 2 head covers. See Figure 1.
3) Remove the fan that blows out (not the other one) by 2 screws to access the lamp.
See Figure 2-3.
4) Push the lamp reflector downward meanwhile grasp the lamp base to pull it out.
5) Remove the 2 wires connected to the lamp by the spade connectors.
6) Reverse the steps above to install the new lamp.
Warning! DO NOT touch the lamp without wearing gloves to avoid leaving grease on
the bulb or on the contacts that could reduce the lamp's life.
I
MPORTANT INFORMATION!
In order to optimize the recovery and recycling of the materials that old
appliances contain and reduce the impact on human health and the
environment, ensure that this product is recycled at the end of its life.
Figure 2
Caution! Always disconnect the product from mains
power and allow it to cool down before any services.
Figure 3
10
Figure 4
Advertisement
Table of Contents
