Adjust The Labelling Position - Valentin WMX 5001 Operating Manual

Wipe-On Applicators
E
D
C
Figure 11
10.23

5.4 Adjust the Labelling Position

NOTICE!
The figure of overview applies to wipe-on applicators WMX
5001 / 5101 / 5201 / 5301.
NOTICE!
In order to operate the printing system with the wipe-on applicator
in the dispenser mode, the dispenser offset must be set to 0.
For a detailed description for adjusting the dispenser offset,
please refer to the chapter Dispenser I/O in the operating manual
of the printing system.
F
1. After correct inserting the label material, press the key
activate a test print of start a measuring procedure to determine
the exact position of the label beginning. Confirm the test print as
long as a label is over the dispensing edge (C) of the wipe-on
applicator.
2. Adjust the dispensing position in such a way that the regular
remove of the label from the backing paper (B) is ensured.
3. Loosen the return pulley by turning the clamping lever (G, Figure
6) against clockwise direction and then shift it slowly downwards.
4. At the same time, turn the internal rewinder (A) to stretch again
the backing paper (B).
Repeat this procedure as long as the label which is to be applied
is removed from the backing paper (C) and exceeds the
dispensing edge (C) approx. 5 mm.
Operating Manual
Adjustments
B A
to
23