HOMCOM EF140N Installation And User Instruction Manual page 10

Remote Operation
Ensure the standby switch, located on the right side of the cold air inlet, is switched on.
It takes some time for the receiver to respond to the transmitter. For correct use, do not
press the buttons repeatedly within two seconds.
1. Boot steps
● Press the power button on the remote control to turn on/off the appliance and fire effect.
● Press the 1000W button for the low heat setting. Press again to switch it off.
● Press the 2000W button for the high heat setting. Press again to switch it off.
● Press the colour button to change the flame to your desired colour.
2. Automatic heating
Press the 'IC' button on the remote controller to enter and exit the automatic heating.
When turned on, the appliance automatically changes the heating mode, depending on
the set temperature and room temperature.
During a timed starting process, it is possible to start heating before schedule.
3. Setting the day and time
1) Use the remote controller for changing the settings.
2) Press the 'DATE TIME' button, then press ▲ or ▼ to select the day.
3) Press the 'DATE TIME' button again, then press the + or - to set the hour.
4) Press the 'DATE TIME' button again, then press + or - to set the minute.
5) Press 'OK' to complete.
4. Temperature setting
The default temperature is 20℃. Press + or - on the remote controller to adjust the
temperature, which ranges from 15-30℃.
NOTE: For the heat to work, the set temperature must be higher than room temperature.
5. Timer setting
1) Description of timer setting
● You can set up to 10 timers, each with a date, power-on time and shutdown time. Each
timer can last for a maximum 23 hours and 50 minutes.
● You can choose which days of the week each timer will be active.
● If the shutdown time fails on the next day, you only need to set the shutdown time and
not the date.
2) Steps to view the timer setting
● Press the 'TIMER SET' button.
● Press + or – to cycle through the timer settings and view the power-on time for each one.
● To check the shutdown time of the timer, press the ▲ button.
Press + or – to continue viewing.
To delete the current setting, press 'C'.
3) Steps for timer setting
(I) Select the settings of the serial number
● Press the 'TIMER SET' button. The item number will start blinking.
● Press + or – to change the serial number to the desired setting you need to modify or
set.
10