Costway SuperFit SP37747US User Manual page 11

EN
1. Lubrication
After the running belt has been used for a period of time, it must be
lubricated with a specially configured methyl-silicone oil.
Advice:
-Use time less than 3 hours a week
-Using 4 ~7 hours a week
-Use time more than 7 hours a week
Do not lubricate too much. It is not the more lubricants the better.
Remember: Proper lubrication is an important factor in improving the life
of the treadmill.
2. As for the way to check whether you
need to add lubricant again. Just grab
the running belt and touch the middle of
the running belt back with your hands as
much as possible. You don't need to add
lubricant if you have silicone on your
hand (a little moist). You have to add
lubricant if the pad is dry and there is no
silicone on your hand.
★ The step of lubricating on the running board (as shown in the picture);
★ Stop the running belt and fold the machine;
★ Lift up the running belt on the bottom, extend the oil into the middle
of the running belt as much as possible, spray methyl-silicone oil on the
inner side of the running belt, and coat both sides of the running belt
with methyl-silicone oil;
★ You can make use of the treadmill speed of 0.6mph to evenly lubricate
and step on the running belt from left to right. After a few minutes, the
methyl silicone oil can be completely absorbed by the running belt.
lubricate every 5 months
lubricate every 2 months
lubricate every month
20
EN
3. Adjust tightness of running belt. All treadmills shall be
adjusted for tightness before delivery and after installation.
However, the running belt may be loosened after a period of use.
For example, the treadmill had stopping and slipping problems
during exercise. When this phenomenon occurs, adjust the
running belt adjustment bolts in a clockwise direction with a half
circle as the unit, left and right synchronously. If the running belt
is too loose, the running belt and the roller will make your feet
slip, but too tight is not good, and it is easy to increase the load
of the motor and damage the motor, running belt and roller.
4. Running belt deviation adjustment
All treadmills need to be adjusted the running belt before delivery and
after installation. But the running belt may be deviated after a period of
use which may be caused by the following reasons.
① The main body is not placed smoothly.
② The feet of users are not in the center of the running belt.
③ The feet of users are uneven force.
The deviation caused by man can be returned to normal after a
few minutes of no-load rotation. For deviation of non-recover
automatically, it should be adjusted with 6mm wrench at a half
circle as the unit.
Please adjust left bolt with
clockwise or right bolt with
counterclockwise if running belt
is left deviation.
Tips: It is mainly maintained by the user according to the manual.
Running belt deviation will seriously damage the running belt.
The mistake must be found in time and corrected.
Please adjust right bolt with
clockwise or left bolt with
counterclockwise if running belt
is right deviation.
21