Toro Groundsmaster e3200 Installation Instructions Manual page 3

4
Installing the Discharge
Cover Plate
Parts needed for this procedure:
1 Discharge cover plate
1 Carriage bolt (5/16 x 7/8 inch)
1
Flange nut (5/16 inch)
2 Carriage bolt (3/8 x 1-1/4 inches)
2 Locknut (3/8 inch)
Procedure
1. Secure the discharge cover plate to the outside
of the mounting bracket using 2 carriage bolts
(3/8 x 1-1/4 inches) and 2 locknuts (3/8 inch) as
shown in Figure
2. Secure the tab to the inside of the mower deck
using 1 carriage bolt (5/16 x 7/8 inch) and 1
flange nut (5/16 inch) as shown in
1. Discharge cover plate
2. Carriage bolt (3/8 x 1-1/4
inches)
3. Tab on the discharge cover
plate
3.
Figure
Figure 3
4. Carriage bolt (5/16 x 7/8
inch)
5. Locknut (3/8 inch)
6. Flange nut (5/16 inch)
5
Installing the Recycler
Baffles
Parts needed for this procedure:
1 Left baffle
1 Center baffle
1 Right baffle
8 Carriage bolt (3/8 x 1 inch)
8 Locknut (3/8 inch)
Procedure
Note:
Loosely install the baffles to align the baffles
with all the holes in the mower deck
1. Position the right baffle into the mower deck.
2. Loosely install the right baffle to the discharge
plate using 1 carriage bolt (3/8 x 1 inch) and 1
locknut (3/8 inch) as shown in
3.
3. Loosely install the right baffle to the mower
deck using 2 carriage bolts (3/8 x 1 inch) and 2
locknuts (3/8 inch) as shown in
4. Position the left baffle into the mower deck.
5. Loosely install the left baffle to the mower deck
using 2 carriage bolts (3/8 x 1 inch) and 2
locknuts (3/8 inch) as shown in
6. Position the center baffle into the mower deck.
7. Loosely install the center baffle to the right baffle
and left baffle using 2 carriage bolts (3/8 x 1 inch)
and 2 locknuts (3/8 inch) as shown in
8. Loosely install the center baffle to the mower
deck using 1 carriage bolt (3/8 x 1 inch) and 1
g306390
locknut (3/8 inch) as shown in
3
(Figure 4).
Figure 4.
Figure 4.
Figure 4.
Figure 4.
Figure 4.