Table of Contents
Advertisement
Operating instruction
As the basis of correct measurement, there are movement warning
and irregular pulse warning. After the signal is displayed, the correct
measured value may not be obtained.
After the measurement, re-measurement is recommended.
(Please rest for 4~5 mins before re-measurement)
The measured values of each signal are also recorded together.
Movement warning
During the measurement, in case of arm or
other movements, when the cuff senses the
excess pressure, the device will flash.
After measurement, it will flash for about
6 seconds and then light up.
When a large abnormal movement is detected for the measured value in
the measurement, [U12] and
will be stopped automatically.
Irregular pulse warning
During the measurement, when the average value
of pulse spacing is ±25%, the device will give an
irregular pulse warning and the [
flash, and then it will light up after flashing for
about 6 seconds.
This mark is not to inform arrhythmia.
※ This function is a reference function set to ensure the accuracy of the measured
value. Even if the [
of the measurement, you are recommended to measure for 2~3 times in a relaxed
state.
※ If the mark appears frequently, you should consult your doctor about your health.
Please do not judge the measurement results by yourself or take
any treatment on such basis. Please follow the doctor's advice.
※ [
same time.
※ In order to prevent the confusion between the name of the product
auxiliary function and "Arrhythmia," adjust "Arrhythmia warning" to
"Irregular pulse warning"
] mark is not displayed, in order to ensure the accuracy
] [
] and the measured value shall be stored at the
About each indication
(Example)
will be displayed and the measurement
(Example)
] mark will
SYS.
DIA.
Pulse
/min
SYS.
DIA.
Pulse
/min
19
Advertisement
Table of Contents
