VINCENT SA-32 Instructions For Use Manual page 15

Hybrid stereo preamplifier
Hide thumbs Also See for SA-32:
Table of Contents

Advertisement

스 스 탠바이 콘트롤 기능을 위한 트리거 연결
CONNECTIONS FOR THE STANDBY CONTROL (POWER CONTROL)
대개 오 오 디오나 비 비 디오 시 시 스템은 많 많 은 기 기 기들로 구 구 성됩니다. 모 모 든 기 기 기의 전 전 원을 하 하 나씩 일 일
일이 켜 켜 고 끄 끄 는 것 것 이 번 번 거로울 수 수 있 있 습니다. 그 그 래서 요 요 즘 p p ower c c ontrol 또 또 는 t t rigger 라 라
하는 기 기 능을 갖 갖 는 기 기 기들이 늘 늘 어나는 추 추 세입니다. 이 이 기 기 능은 일 일 종의 원 원 격 전원 스위치으로
서, 시 시 스템의 한 한 기 기 기(주 주 로 프 프 리앰프)에 에 서 전 전 원을 끄 끄 거나 켜 켜 면 서 서 로 연 연 결된 기 기 기의 전 전 원을
동시 켜 켜 고 끌 끌 수 수 있 있 습니다. 특 특 히 파 파 워앰프가 프 프 리앰프에서 멀 멀 리 떨 떨 어져 위 위 치하는 경 경 우 이 이
기능이 유 유 용하게 쓰 쓰 입니다. 참고로 이 이 기 기 능은 전 전 원을 완 완 전히 끄 끄 는 것 것 이 아 아 니고 상 상 대방 기 기 기
의 전 전 원을 스 스 탠바이 상 상 태로 둡 둡 니다.
Many AV-Systems consist of a multitude of individual components. To avoid the necessity of switching them on
and off before and after every use, many manufacturers have equipped their devices with what is known as
"POWER CONTROL" circuit or "TRIGGER". This kind of remote-controlled standby circuit is used primarily for
preamplifier and power amplifiers. Particularly for pre-amplifiers and main amplifiers, this kind of remote standby
control is utilized, as power amplifiers are often placed far from other devices near the speakers. To employ these
functions, direct or indirect cable connections must be made between the preamplifier (or integrated amplifier)
and all the devices which support this function. The "POWERCONTROL" function operates in such a way that
each switching on or off of one device in the system (usu-ally the preamplifier) automatically brings about the
switching on or off of all the connected devices which support this function. Please keep in mind that all devices
which respond to the power control are not dis-connected from the mains network when switched off. They are
set to a standby state instead. For con-necting cables, two-core cables with 3.5 mm jack plugs (mono) are used. For
each connection between two devices one of those cables is needed.
If you don't wish to use this function or if the other components do not support it, all you have to do is leave out
these cable connections.
Vincent
33

Advertisement

Table of Contents
loading

Table of Contents