Advertisement
BATTERY
PACK/CHARGER
The battery pack and charger are not included with
your worklight. They are both sold separately. When
purchasing, use the following information:
MODEL NO.
BATTERY PACK
CHARGER
973.113911
item No. _911375
item No. _9 11041
(1323517 or 1323903)
(1425301)
BATTERY
PACK
The battery pack for your worklight has been shipped
in a low charge condition to prevent possible prob-
lems. Therefore, you should charge it until light on
front of charger changes from red to green.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (operating
worklight followed by recharging) for batteries to
become fully charged.
CHARGING
BATTERY
PACK
See Figure 1.
[]
Use only the recommended
battery pack and
charger with your worklight.
[]
Make sure power supply is normal household
voltage,
120 volts, 60 Hz, AC only.
[]
Connect charger to power supply.
[]
Place battery pack in charger aligning raised
rib on battery pack with groove in charger.
See Figure 1.
[]
Press down on battery pack to be sure contacts
on battery pack engage properly with contacts in
charger.
[]
Normally, the red LED on charger will come on.
This indicates charger is in fast charging mode.
[]
Red LED should remain on for approximately
1
hour then the green LED will come on. Green LED
on indicates battery pack is fully charged and
charger is in trickle charge mode. Note: Green
LED will remain on until battery pack is removed
from charger or charger is disconnected
from
power supply.
BATTERYPACK
SHOWNIN CHARGER
CHARGER
[]
If both yellow and green LED come on, this
indicates a deeply discharged or defective battery
pack.
Allow battery pack to remain in charger for 15 to
30 minutes. When battery pack reaches normal
voltage range, red LED should come on.
If red LED does not come on after 30 minutes, this
indicates a defective battery pack and should be
replaced.
[]
After normal usage, a minimum of 1 hour of
charging time is required to fully recharge battery
pack.
[]
The battery pack will become slightly warm to the
touch while charging. This is normal and does not
indicate a problem.
[]
Do not place charger and battery pack in an area
of extreme heat or cold. It will work best at normal
room temperature.
Note: Charger and battery pack should be placed
in a location where the temperature
is more than
50°F but less than 100°R
[]
When batteries become fully charged, unplug
charger from power supply and remove the bat-
tery pack.
iNFORMATION
FOR RECHARGING
HOT
BATTERY
PACK
When using your worklight continuously, the batteries
in your battery pack will become hot. You should let a
hot battery pack cool down for approximately
30 min-
utes before attempting to recharge. When the battery
pack becomes discharged and is hot, this will cause
the green LED to come on instead of the red LED.
After 30 minutes, reinsert battery pack in charger. If
green LED continues to remain on, return battery pack
to your nearest Sears Repair Center for checking or
replacing.
Note: This situation only occurs when continuous
use of your worklight causes the batteries to become
hot. It does not occur under normal circumstances.
Refer to "CHARGING BATTERY PACK" for normal
recharging of batteries. If the charger does not charge
your battery pack under normal circumstances,
return
both the battery pack and charger to your nearest
Sears Repair Center for electrical check.
REDLED ON INDICATES
FASTCHARGING MODE
GREENLEDON AFTERFAST CHARGING
CYCLE,iNDICATES FULLYCHARGED BATTERY
PACKANDIN TRICKLECHARGE MODE.
YELLOWANDGREENLED8
ON INDICATES DEEPLY
Fig. 1
Advertisement
