Toshiba Satellite L505-GS5035 User Manual page 142

L500/L505/L500D/L505D
Battery
If you suspect a problem with the battery, you should check the status of
the DC IN indicator as well as the Battery indicator. Please refer to
Chapter 6,
indicators, together with general battery operation.
Problem
Battery doesn't
power the computer
Battery doesn't
charge when the AC
adaptor is attached
(Battery indicator
does not glow
amber).
Battery doesn't
power the computer
as long as expected
9-6
Power and Power-up
Procedure
The battery may be discharged - connect the AC
adaptor to recharge the battery.
If the battery is completely discharged, it will not
begin charging immediately, in these instances you
should wait a few minutes before trying again. If
the battery still does not charge, you should check
that the power outlet to which the AC adaptor is
connected is supplying power - this can be tested
by plugging another appliance into it.
Check whether the battery is hot or cold to the
touch - if so, it will not charge properly and should
be allowed to reach room temperature before you
try again.
Unplug the AC adaptor and remove the battery to
make sure its connecting terminals are clean - if
necessary wipe them with a soft dry cloth lightly
dipped in alcohol.
Connect the AC adaptor and replace the battery,
taking care to ensure that it is securely seated in
the computer.
Check the Battery indicator - if it does not glow,
allow the computer to charge the battery for at
least twenty minutes. If the Battery indicator starts
to glow after this period, allow the battery to
continue to charge for at least another twenty
minutes before turning on the computer. However,
if the indicator still does not glow, the battery may
be at the end of its operating life and should be
replaced. However, if you do not believe the
battery is at the end of its operating life, you should
speak to your reseller, dealer or service provider.
If you frequently recharge a partially charged
battery, the battery might not charge to its full
potential - in these instances you should fully
discharge the battery and then attempt to charge it
again.
Check the Power saver option under Select a
power plan in the Power Options.
Modes, for more information on these
User's Manual