Timer; Setting The Timer Start Time; Using The Timer; Alarm - Casio G-SHOCK MTG-B2000PH-2A Operation Manual

Timer

The timer counts down from a start time
specified by you. A beeper sounds when the
end of the countdown is reached.
The beeper is muted when battery power is
●
low.

Setting the Timer Start Time

1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
first click.
3.
Rotate the crown to change the
countdown start time setting.
The countdown start time can be set in
●
1-minute units up to 24 hours.
Seconds
Hours 24-hour
Minutes
4.
Push the crown back in and then lock it.
Note
To specify a countdown start time of 24
●
hours, align the small hour and minute
hands with 12 o'clock, so the small 24-
hour hand aligns with 24.
You can also use CASIO WATCHES
●
to configure timer settings.
Watch Operation Guide 5636

Using the Timer

1.
Enter the Timer Mode.
Navigating Between Modes
l
2.
Press (D) to start the countdown.
A beeper sounds for 10 seconds when the
end of the countdown is reached.
To pause an ongoing countdown, press
●
(D). To reset a paused countdown to the
start time, press (A).
3.
Press any button to stop the tone.
The watch will beep when the alarm time is
reached.
The beeper is muted in the cases described
●
below.
When battery power is low
ー
While the watch is at Level 3 power
ー
saving
Power Saving
l
Seconds
Hours 24-hour
Minutes

Alarm

Configuring Alarm Settings

1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Loosen the crown and then pull it out to the
first click.
This turns on the alarm.
3.
Rotate the crown to change the alarm time
setting.
Alarm on
Hour Minute
4.
Push the crown back in and then lock it.
To stop the alarm
●
To stop the alarm after it starts to sound when
an alarm time is reached, press any button.
Note
A beeper sounds for 10 seconds when
●
an alarm time is reached.
You can also use CASIO WATCHES
●
to configure alarm time settings.

Turning Off the Alarm

To stop the alarm from sounding, perform the
steps below to turn it off.
To have the alarm sound again, turn it on.
●
1.
Enter the Alarm Mode.
Navigating Between Modes
l
2.
Press (D) to move the second hand to
OFF.
Each press of (D) toggles between on
●
and off.
Alarm on
Alarm off
Crown
16