Advertisement
Installation Instructions
[9]GARAGE INSTALLATION (IF ALLOWED
BY LOCAL CODES)
¢ Dryers installed in garages must be elevated 18 inches
(46cm) above the floor.
[LOIDRYER EXHAUST TO RIGHT, LEFT
OR BOTTOM CABINET
A, WARNING - werore PERFORMING
THIS EXHAUST INSTALLATION, BE SURE
TO DISCONNECT THE DRYER FROM ITS
ELECTRICAL SUPPLY. PROTECT YOUR HANDS
AND ARMS FROM SHARP EDGES WHEN
WORKING INSIDE THE CABINET. BE SURE TO
WEAR GLOVES
REMOVE
SCREW
AND SAVE.
REMOVE
DESIRED
KNOCKOUT
(ONE ONLY).
Detach and remove the bottom, right or left side knockout
as desired. Remove the screw inside the dryer exhaust duct
and save. Pull the duct out of the dryer.
Note: Only 4" round rigid metal ducting allowed inside
dryer.
FIXING HOLE
a
EZ
Cut the duct as shown and keep portion A.
TAB LOCATION
BEND TAB
UP 45 °
Through the rear opening, locate the tab in the middle of
the appliance base. Lift the tab to about 45° using a flat
blade screwdriver.
ADDING NEW DUCT
FIXING
HOLE
PORTION "A"
RIGHT OR
LEFT SIDE
EXHAUST
Reconnect the cut portion (A) of the duct to the blower
housing. Make sure that the shortened duct is aligned with
the tab in the base. Use the screw saved previously to secure
the duct in place through the tab on the appliance base.
ADDING ELBOW AND DUCT FOR
EXHAUST TO LEFT OR RIGHT SIDE OF
CABINET
¢ Preassemble 4" elbow with 4" duct. Wrap duct tape
around joint.
¢ Insert duct assembly, elbow first, through the side
opening and connect the elbow to the dryer internal
duct.
CAUTION:
Be sure not to pull or damage the
electrical wires inside the dryer when inserting the
duct.
EXHAUST CAN
BE ADDED TO
LEFT OR RIGHT SIDE
Advertisement
