Bosch NDP-5512-Z30C User Manual page 30

30 en | Camera
You can change individual parameter values of a profile and you can also change the name.
You can switch between profiles by clicking the appropriate tabs.
Caution!
The profiles are rather complex. They include a large number of parameters that interact with
!
one another, so it is generally best to use the default profiles.
Change the profiles only once you are fully familiar with all the configuration options.
Note: In the default setting, Stream 1 is transmitted for alarm connections and automatic
connections.
Notice!
All parameters combine to make up a profile and are dependent on one another. If you enter
a setting that is outside the permitted range for a particular parameter, the nearest permitted
value will be substituted when the settings are saved.
Profile name
If required, enter a new name for the profile.
Bit rate optimization
The bit rate optimization defines the optimization strength. These must be combined with the
appropriate scene mode. The Bit rate optimization and Maximum bit rate work in a quality-
driven mode. The encoder generates a bit rate up to the maximum setting if the scene
requires it.
For maximum image quality, apply minimum bit rate reduction (Maximum quality). This will
also greatly increase the file size. If maximum bit rate reduction is applied, the image will have
less quality, but the file size decreases significantly (Minimum bit rate).
Select the necessary bit rate optimization setting:
–
–
–
–
–
–
Averaging period
Select the appropriate averaging period as a means of stabilizing the long term bit rate.
Target bit rate
To optimize use of the bandwidth in the network, limit the data rate for the device. The target
data rate should be set according to the desired picture quality for typical scenes with no
excessive motion.
For complex images or frequent changes of image content due to frequent movements, this
limit can temporarily be exceeded up to the value entered in the Maximum bit rate field.
Note: You can change the value in this field only if you select a duration in the field Averaging
period. If you do not select an Averaging period, then the field Target bit rate is greyed out.
Encoding interval
The Encoding interval slider determines the interval at which images are encoded and
transmitted. This can be particularly advantageous with low bandwidths. The image rate is
displayed next to the slider.
Video resolution
Select the desired resolution for the video image.
Note: The value in this field adjusts the resolution for SD streams only.
2019-11 | 1.2 |
Off: bit rate optimization is disabled
Maximum quality
High quality
Medium
Low bit rate
Minimum bit rate
User Manual
AUTODOME IP starlight 5000i
Bosch Security Systems