Completion & Cleanup; Lowering The Auger - HARVEST A1072 Operator's Manual

If auger is full of grain, do not restart at full speed. Engage PTO at low
RPM and gradually increase power until normal operating speed is
achieved.
CAUTION:
Starting the auger under load may result in damage to the auger.
Make sure there is no blockage.
4.6 Completion and Cleanup
At completion of operation, the auger needs to be moved into storage
position. Make sure that the entire work area is clean, remove all
supports and wheel chocks, move auger out of working position, and
fully lower the auger (see lowering procedure below).
The proper steps for clean out of the auger are as follows:
1) Disengage power source; lower the auger into transport
position.
2) Shut off tractor and lock out power.
3) Move intake hopper into transport position and latch with safety
chain.
4) If necessary, clean out grain using small shovel or other tool.
WARNING:
Do not leave auger in raised position when not in use. Auger could
drop rapidly in case of hydraulic failure. High winds may also upset
the auger. Because the hydraulic scissor lift is faster than a hand
crank system, use extra caution and clear area of personnel before
raising or lowering auger.

4.7 Lowering the Auger

Check that auger and hose couplers are securely attached to your tractor.
You may need to raise the auger discharge end up and out of bin or
storage facility before proceeding.
Remove wheel chocks, and check that the area around and under the
auger is clear of debris and unauthorized personnel. Wheels must be free
to move when raising or lowering the auger.
_
_
14