Advertisement
Available languages
Available languages
Be careful not to insert the cutting element
too deep into the nostrils (max. 15/32
in./12 mm).
3 Move the cutting element in and out of the
nostril in a firm, rotary motion to cut the
hairs to a shorter length (Fig. 19). Make
sure that the cutting teeth touch the hair
by rotating the cutting element inside your
nostril. While rotating you may hold the flat
side of the trimmer against the skin to
reduce any tickling effect that might occur.
4 Clean thoroughly after each use (see
'Cleaning').
Tip: You can also trim hairs in the nostrils using
the rotary trimmer (see 'Using the rotary
trimmer').
Trimming neck hair
You can trim your neck hair using the cutting
element of the trimming head.
1 Pull skin taut with one hand and place the
trimmer gently on the skin.
2 Move the cutting element slowly over the
skin against the direction of hair growth
making sure the cutting element is in
complete contact with the skin.
3 Clean the cutting element thoroughly after
each use (see 'Cleaning').
Using the rotary trimmer
The rotary trimmer attachment can also be
used to trim hairs in the nostrils or ears.
1 Attach the rotary trimmer to the product
(see 'Detaching and attaching the
attachments').
2 Gently insert the rotary trimmer into your
nostril or outer ear channel.
Do not insert the trimming head too deep
into your nostrils or ear channels (max.
3/16 in. / 5 mm).
3 When trimming both nose and ear hair,
make firm, rotary movements to ensure
that the trimming head reaches all the
hairs.
4 Clean the attachment thoroughly after
each use.
Cleaning
Make sure that the battery compartment is
properly closed before rinsing the product
under the tap.
Never use scouring pads, abrasive cleaning
agents or aggressive liquids such as
gasoline or acetone to clean the product or
any attachments or accessories.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the
cutting elements.
Clean the trimming head and eyebrow guards
immediately after use and when a lot of hair
or dirt has accumulated on the cutting
elements.
1 Use the cleaning brush to remove any
excess hair from the cutting element (Fig.
20).
2 Rinse the cutting element with lukewarm
water under the tap.
3 Switch on the product and rinse the cutting
element again (Fig. 21) to remove any
remaining hairs. Then switch off the
product again.
4 If the rotary trimmer is attached, detach it
from the handle. Turn the rotary trimmer
upside down and rinse it with lukewarm
water (Fig. 22).
Tip: For a thorough clean, immerse the
trimming head in a glass with warm water
for ca. 30 minutes to soak and soften the
debris (Fig. 23). Be careful not to immerse
the handle in water. Then switch on the
product and rinse the cutting element
under the tap to remove stubborn
hair/debris.
5 Rinse the eyebrow guards with lukewarm
water (Fig. 24). You can also use the
cleaning brush to clean the eyebrow
guards.
6 Carefully shake off excess water and let all
parts air-dry (Fig. 25).
Storage
Store the product in a safe, dry location.
Ensure that the product and accessories are
completely dry before storage, or before
inserting them into the pouch if provided.
Advertisement
