Daikin Siesta ATXM20A2V1B Operation Manual page 14

5 Operation
a Daikin eye
b Partly green
c Red, orange or blue
Daikin eye colour alternates
between partly green and...
Red
orange
blue
4 Press to exit the menu.
Result: The display will return to the default screen.
To connect the wireless LAN to your home
network
The wireless adapter can be connected to your home network using
the:
▪ WPS button (Wi-Fi Protected Setup) on the router (if present),
▪ The SSID (Service Set Identifier) and the KEY (password) -
located on the unit.
To connect using the WPS button
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
orange and partly green.
4 Press the WPS button on your communication device (e.g.
router) within approximately 1 minute. Refer to the manual of
your communication device.
Result: The Daikin eye colour alternates between blue and
partly green.
Operation manual
14
b
c
a
...then wireless adapter is...
not connected
running and ready to connect to
the home network via WPS
button; see "To connect using
button" [ 4 14].
the WPS
connected to the home network:
▪ via SSID + KEY.
or
▪ via the WPS button on the
router.
for at least 5 seconds while
by pressing once or
1×
INFORMATION
If the connection with your router is not possible, try
procedure "To connect
number" [ 4 14].
5 Press to exit the menu.
Result: The display will return to the default screen.
To connect using SSID and KEY number
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Press to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
red and partly green.
4 Open the ONECTA application on your smart device and follow
the steps on the screen.
Result: If the connection was successful, the Daikin eye colour
alternates between blue and partly green.
5 Press to exit the menu.
Result: The display will return to the default screen.
To reset the connection setting to the factory
default
Reset the connection setting to the factory default in case you want
to:
▪ disconnect the wireless LAN and the communication device (e.g.
router) or smart device,
▪ repeat the setting if the connection was unsuccessful.
1 On home screen menu, hold
the unit is not operating.
Result: The SP menu appears. is blinking.
2 Change to the SP menu
repeatedly.
(5 sec.)
3 Hold for at least 2 seconds to confirm the selection.
Result: is blinking. The Daikin eye colour alternates between
red and partly green. The setting is reset to the factory default.
4 Press to exit the menu.
Result: The display will return to the default screen.
To turn off the wireless LAN connection
If you want to turn off the wireless connection function:
1 On home screen menu, press
the unit is not operating.
Result: The SP menu appears. is blinking.
using SSID and KEY
for at least 5 seconds while
by pressing twice or
2×
for at least 5 seconds while
by pressing twice or
2×
for at least 5 seconds while
ATXM-A
Daikin room air conditioner
3P728539-4 – 2023.06