Table of Contents
Advertisement
Introductions
With this Remote Control, you can operate your TV and
most models of remote-controlled VCR's and Cable TV
converters even if they are different brands.
However, this Remote Control must first be programmed
to control other brands of VCR's and/or Converters. If
you will be using your TV set with
a TOSHIBA VCR, your
Remote has already been preprogrammed for you.
€ Before attempting to operate your Remote Control,
install the batteries according to the section "To install
batteries" shown below.
e For more detailed instructions, see the section "Pro-
gramming the Remote Control" on page 9.
Notes:
ө After installing new batteries, the Remote Control will
set itself to the codes for TOSHIBA's TV and VCR. If
you are using the Remote Control to operate equip-
ment that uses different codes, it will have to be
reprogrammed for those codes.
e This Remote Control may have functions not available
on the original remote controller.
e These functions may or may not operate your VCR or
Cable TV Converter. Refer to the owner's manuals
supplied with the equipment to see which functions
are available.
e The remote controller supplied with your VCR or Cable
TV Converter may have keys not duplicated on this
Remote Control. If these functions are desired, the
original remote controller will have to be used.
Location
of Controls
(Remote
Control)/
Before
Using
the
Remote
Control
To install batteries
1
Place the Remote Control with the face down. Press
down on the ridged area of the battery cover and
slide it off.
Press and slide to remove.
2 Place two "AA" size alkaline batteries, matching the +
and - signs on each battery to the + and – signs of
the battery compartment.
3 Replace the battery cover until the lock snaps.
CAUTION:
ө Do not throw your batteries into a fire. Dispose of your
batteries in a designated disposal area.
e Do not combine used old batteries with new ones.
€ Do not mix battery types.
Tips for Best Operation
e For optimum performance, aim the Remote Control
directly at the TV from a distance of no more than 16 ft
(bm) and be sure there is no obstruction between the
Remote Control and the TV.
ө If your Remote Control does not always adjust the TV
as you wish, you probably need to replace the
batteries.
Use alkaline batteries for longer use.
e Remove dead batteries immediately to prevent battery
acid from leaking into the battery compartment.
e |f you do not intend to use the Remote Control for a
long period, remove the batteries.
PREPARAT
Advertisement
Table of Contents
