Switching On/Off; Setting The Instrument; Reference Setting; Operation - Makita LD060P Instruction Manual

GB
abnormal use, and before, during and after important
measurements.
Make sure the Makita LD060P optic is kept clean and
that there is no mechanical damage to the bumpers.
A
CAUTION:
In using the instrument for distance measure¬
ments or for positioning moving objects (e.g. cranes,
building equipment, platforms, etc.) unforeseen
events may cause erroneous measurements.
Precautions:
Only use this product as a measuring sensor, not as
a control device. Your system must be configured and
operated in such a way, that in case of an erroneous
measurement, malfunction of the device or power
failure due to installed safety measures (e.g. safety
limit switch), it is assured that no damage will occur.
Switching on/off
ON
lx briefly: the instrument and the laser are swit¬
ched on.
The display shows the battery symbol ||j until
the next button is pressed.
Pressing this button for longer switches the
instrument off.
The instrument switches off automatically after
three minutes of inactivity.
Operation
Setting the instrument
PH Press long until the desired unit is displayed.
Possible units:
Distance Area Volume
1. 0.000 m 0.000 m2 0.000 m3
2.
0'0" Vi6
0.00 ft2 0.0 ft3
3.
o in Vi6
0.00 ft2 0.0 ft3
4. 0.00 ft
0.00 ft2 0.0 ft3
CLEAR-Key
lx briefly: the last action is cancelled.
Illumination
lx briefly: the display illumination is switched on
or off.
Reference Setting
Default reference setting is from the rear of the
instrument.
The instrument can be set for the following measure¬
ments:
• To measure from an edge (see drawing {D}), fold
out the stop bracket until it snaps in for the first
time. See drawing {E}.
• To measure out of a corner (see drawing {D}),
fold out the stop bracket until it snaps in, push
Makita LD060P