Indirect Measurement - Determining A Distance Using 2 Auxilliary Measurements; Indirect Measurement - Determining A Distance Using 3 Auxilliary Measurements; Stake Out Function - Makita LD060P Instruction Manual

• All target points must be vertical or horizontal on
the surface of the wall.
• The best results are achieved when the intrument
is rotated around a fixed point (e.g. the stop
bracket is fully extended and the instrument is
placed against a wall).
• To take the measurement, the minimum/
maximum function can be called up. The minimum
value is used for measurements that must be at
right-angles to the target; the maximum distance
is used for all other measurements.
Make sure that the first measurement and the
distance to be measured are at right angles. Use the
minimum/maximum function.
Indirect measurement - determining a
distance using 2 auxilliary measurements
See drawing {G}
3x briefly: the l\ symbol is displayed.
The distance to be measured flashes in the symbol.
' I lx briefly: takes a measurement of the distance
The second distance to be measured flashes in the
symbol
j lx briefly: takes a measurement of the hori¬
zontal distance
The result of the function is displayed in the summary
row.
If the
ON
button is pressed for along time while
Makita LD060P
measuring a distance, maximum or minimum conti¬
nuous measuring is activated.
Indirect measurement - determining a
distance using 3 auxilliary measurements
See drawing {H}
l\
4x briefly: the symbol is displayed.
The distance to be measured flashes in the symbol,
j lx briefly: takes a distance measuement
The second distance to be measured flashes in the
symbol
j lx briefly: takes a horizontal measurement.
The third distance to be measured flashes in the
symbol
| lx briefly: takes a measurement of the distance
The result of the function is displayed in the summary
row. _
If the button is pressed for along time while
measuring a distance, maximum or minimum conti¬
nuous measuring is activated.
Stake out function
This function is helpful when staking out equal
distances, e.g in the erection of wooden substruc¬
tures. See drawing {1}
5x briefly: the - j—/ - symbol is displayed.
A value is displayed in the summary row (default
GB
Functions