Alpine MRV-F400 Owner's Manual page 16

4/3/2 channel power amplifier

Refer to Fig. 2 on page 4.

Due to the high power output of the MRV-F400, considerable heat is produced

when the amplifier is in operation. For this reason, the amplifier should be mounted in

a location which will allow for free circulation of air, such as inside the trunk. For

alternate installation locations, please contact your authorized Alpine dealer.

1. Using the amplifier as a template, mark the four screw locations.

2. Make sure there are no objects behind the surface that may become damaged

during drilling.

3. Drill the screw holes.

4. Position the MRV-F400 over the screw holes, and secure with four self-tapping

screws.

NOTE:

To securely connect the ground lead, use an already installed screw on the metal

part of the vehicle (marked (*)). Be sure this is a good ground by checking continuity

to the battery (—) terminal. As much as possible connect all equipment to the same

ground point. These procedures will help eliminate noise.

@ Ground Lead

@ Chassis

® Holes