Advertisement
tanks are seated firmly, turn the unit on, and recline the handle. Push the unit forward
continuously about 3-4 times or until water comes out of the bottom. Power ON again.
3.
Unit may need to be reset.
To reset the PowerDash, unplug it from the wall. Remove the nozzle cover and take out the
brushes. Now, replace the nozzle cover, plug the unit back in, and cycle the power on and off
4 times. Replace the brushes and test to see if the reset worked.
C. Accessory Hose/Tool Won't Dispense (ONLY for PowerDash Pet Complete)
1. Check to ensure that Clean Water Tank and Solution Tanks are full.
2. Ensure there are no clogs in the hose end.
(1) Check both ends of the hose and clean any clogs or debirs you may encunter. Make sure
they also clean the accesory tools.
(2) Insert a small object into the hose solution port to ensure is not clogged.
3. There may be air trapped in the hose and pump. In this case, you will need to prime the pump
by lowering the hose to the floor and holding the trigger for up to one minute.
D. Unit Won't Pick Up or Has Poor Suction
1. Dirty Water Tank is Full (Float Engaged), the float can also be tripped if the unit is lifted
from the floor while is ON.
(1) Turn off the unit and empty the Dirty Water Tank. They will notice the float goes back to
its original position.
2. The Nozzle is not secure
(1) Pull up on the latch and pull forward to remove the nozzle cover. Check the nozzle
opening for any clogs or blockages. To replace the nozzle cover, line up the two tabs on
the base as well as the tabs close to the opening. Push down and backward until the latch
clicks into place.
(2) On the PowerDash Pet Complete there a quick access to the brush roll for cleanup. See
picture 2 below.
Advertisement
