Table of Contents
Advertisement
Getting Started
Unpacking
¢ Remote controller (remote) (1)
« Size AA (R6) batteries (2)
Inserting batteries into the remote -
Insert two size AA (R6) batteries in accordance with
the + and — marking on the battery compartment.
When using the remote, point it at the remote sensor
on the amplifier.
je When to replace batteries
Under normal use, the batteries should last for about 6
months. When the remote no longer operates the
amplifier, replace both batteries with new ones.
Notes
* Do not leave the remote in an extremely hot or humid
place.
3 Do not use a new battery with an old one.
* Do not expose the remote sensor to direct sunlight or
lighting apparatuses. Doing so may cause a malfunction.
.
* If you don't usé the remote for an extended period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Hookup Overview
The amplifier allows you to connect and control the
following audio/video components. Follow the
hookup procedures on the specified pages for the
components that you want to connect to the amplifier.
To learn the locations and names of each jacks, see
"Rear Panel Descriptions" on page 18.
Speaker
Audio/Video Component
System
Hookups (5)
Hookups (6)
VCR
'
Turntable
Audio/Video Component
Hookups (5)
Before you get started
* Turn off the power to all components before making
any connections.
* Do not connect the AC power cords until all of the.
connections are completed.
* Be sure to make connections firmly to avoid hum
and noise.
* When connecting an audio cable, be sure to match
the color-coded pins to the appropriate jacks on the
components:
White (left, audio) to White; and Red
(right, audio) to Red.
Advertisement
Table of Contents
