Product View - Scandomestic WFF168W User Manual

Table of Contents

Advertisement

Available languages

Available languages

Productview
A Cabinet
B Freezer drawers
C Adjustable feet
D Thermostat knob
Placement
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
For refrigerating appliances with climate
class:
-
extended temperate: 'this refrigerating
appliance is intended to be used at
ambient temperatures ranging from
10°C to 32°C (SN);
-
temperate: 'this refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16°C to 32°C
(N);
-
subtropical: 'this refrigerating appliance
is intended to be used at ambient
temperatures ranging from 16°C to 38°C
(ST);
-
tropical: 'this refrigerating appliance is
intended to be used at ambient
temperatures ranging from 16°C to 43°C
(T);
Location
The appliance should be installed well away
from sources of heat such as radiators,
boilers, direct sunlight etc. Ensure that air
can circulate freely around the back of the
cabinet. To ensure best performance, if the
appliance is positioned below an
overhanging wall unit, the minimum
distance between the top of the cabinet
and the wall unit must be at least 50 mm.
Ideally, however, the appliance should not
be positioned below overhanging wall
units. Accurate leveling is ensured by one
or more adjustable feet at the base of the
cabinet.
This refrigerating appliance is not intended
to be used as a built-in appliance.
Warning! It must be possible to disconnect
the appliance from the mains power
supply; the plug must therefore be easily
accessible after installation.
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power
supply socket is not earthed, connect the
appliance to a separate earth in compliance
with current regulations, consulting a
qualified electrician.
The manufacturer declines all responsibility
if the above safety precautions are not
observed.
This appliance complies with the E.E.C.
Directives.
Space requirement
• Keep enough space of door open.
• It is advisable to keep at least 10mm gap
at two sides.

Advertisement

Table of Contents
loading

Table of Contents