Panasonic PT-LC75U Service Manual page 29

5.7. Signal Selector Connecting Cable Specifications
When connecting to a signal selector (ex. TW-SWS62J), use a cable with specifications below.
Connecting method: Connects a video signal cable from the signal selector to "VIDEO IN", and an
RGB signal cable to "RGB1 IN".
Note:
Set VP control terminal switch of the signal selector to VP TYPE "B".
6. Disassembly Instructions
Warning:
- Be sure to unplug the power cord from the power outlet before
disassembling this projector.
Caution:
- While turning over a printed circuit board, be sure to put a
insulating material under it to prevent a short circuit.
- Printed circuit boards and wires must not be pulled forcibly, but be
handled carefully.
- Connectors also must be handled carefully.
- After repairing this projector, be sure to put back the wires and
connectors to the original condition.
6.1. Printed Circuit Board and Main Parts Location
Electrical Parts
14