ABB Slimline Power Shelf SPS-48V Quick Start Manual page 3

Hide thumbs Also See for Slimline Power Shelf SPS-48V:

Step 5 – Connect Open String Alarm – Some Models - Optional

Connect OS Alarm as directed in site installation instructions.

J3 1-Wire Battery

Temp Monitor

J5 LAN Port

Step 6 – Set Jumpers – LAN Port and Relay per Galaxy Pulsar Edge Controller

Quick Start Guide

Step 7 – Install Controller per Galaxy Pulsar Edge Controller Quick Start Guide

Step 8 – Install Signal and Communications Cables

Connectors are on rear.

J1-2 Alarms and Inputs - Connect to office alarms and signals.

See Information: Alarm Connections for Details

LAN - Connect to Ethernet network.

Step 9 – Install 1-Wire Battery Temp and Voltage Monitor per Galaxy Pulsar

Edge Controller Quick Start Guide – Optional

1. Connect 1-Wire Battery Temp and Voltage Monitor to J3.

Step 10 – Install Rectifiers

Firmly push the rectifier into the rectifier slot.

Tighten the thumb screw until the rectifier is seated.

NOTE: When installing a rectifier in a powered system the RUN LED on the

rectifier will blink until communication with the controller is

established.

Page 3

J2 Alarm inputs

J1 Alarm outputs

Signal Connections

SPS Shelf L002_QSG

USB Craft Port

Rev 5.0

Table of Contents

J2007003l002