Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Z3 Technology Zeus
Summary of Contents for Z3 Technology Zeus
- Page 1 Performing a System Reinitialization Manual Version 1.00.01 March 29, 2014...
- Page 2 Performing a System Reinitialization Revision History Version Date Change Note Author 1.00.00 10/03/13 Initial Version 1.00.01 03/29/14 Added settings to use for other platforms ___________________________________________________________________________________________ Z3 Technology, LLC ♦ 100 N 8 ST, STE 250 ♦ Lincoln, NE 68508-1369 USA ♦ +1.402.323.0702...
- Page 3 The procedure for doing this within Windows and within Linux is described. These commands should be run from the same PC that the Web GUI for the Zeus Encoder is being accessed from. 2. Doing a System Reinitialization from Windows (1) In the lower left corner, select “start”...
- Page 4 Command for the MVPR-02 shown below as an example: (4) You should then see a login prompt (the exact type will depend on the Zeus product used). At this prompt, type “arago login:” prompt. Type “root” and <return>. [MVPR-02 login shown below].
- Page 5 3. Doing a System Reinitialization from Linux (1) On the Linux PC you’re using to connect to the Zeus encoder, open a Terminal window and type “telnet x.y.z.w”, where x.y.z.w is the IP address of the Zeus encoder box. Default IP settings are as follows: DME-01, MVE-02, MVE-20, MVPR-01: 192.168.0.65...
Need help?
Do you have a question about the Zeus and is the answer not in the manual?
Questions and answers