Sharp mz-800 Owner's Manual page 207

Pen position Pe
detection magnet Pa
Pen holder
Green
Red
—
es
Pen eject lever
= Storing pens
Install the pens only when the printer is used.
When the printer is not used, remove the pens and cap them, then keep them in the refill container;
otherwise, they will be dried up.
-co- a>
—_S——
| oan cap
| Pin Pen cap
Refill container
Note:
Because the ball-point pens use water-soluble ink and the ink may blur if the printed paper becomes
wet, the paper should be handled with care.
= Replacements for the printer pens (ball-point pens) can be purchased at the same
dealer you purchased the printer from.
© EA-850B (black: 4 pens)
* EA-850C (black, blue, green, red: 4 pens, 1 of each colour)
m Self-test
The plotter-printer has the self-test function. Press and hold the (™§) (paper feed) key and turn on the
MZ-800 power, and the self-test starts. It is recommended to perform the self-test after pens have been
replace.
Note:
Be sure to disconnect the interface cable when performing the self-test.
A-20