Preface - Reliance electric GV3000 Installation Instructions Manual

PREFACE
The products described in this manual are manufactured or distributed by Reliance Electric Industrial
Company.
This manual providesinstructions for replacing the Regulator board in your installation with a GV3000®
Version 4 Regulator board. It is intended for qualified electrical personnel. The Regulator boardis sold
individually as P/N 056921 -4xx or 413338-5AU and as part of Upgrade Kit P/N K-690-AU or K-690-AV.
You will need to refer to the following instruction manuals as you perform the installation procedure. These
manuals are shipped with the new Regulator board.
e@ D2-3323 GV3000 A-C General Purpose (Volts/Hertz) and Vector Duty Drive Software Start-Up and
Reference Manual
@ D2-3324 GV3000 A-C Power Modules Hardware Reference, Installation, and Troubleshooting
The installation procedure consists of replacing the Regulator board, identifying the Power Module to the
Regulator board, and restoring your configuration. Perform the instructions in the order in which they are
presented in this manual. The board replacement procedurediffers depending on drive type. Use the
following table to locate the appropriate installation procedure in this manual.
If your drive's model number is notlisted below, the regulator software may not be compatible for your drive.
Contact Reliance Renewal Parts for a compatible Regulator board.
For Drive Replace the Regulator Using the Procedure
Model Number... Board with Part Number... Beginningin Section...
1V41x0
4V44x0 0-5692 1 -4xx 1.0
2V41x0
1-5HP oVAdx0 0-5692 1 -4xx 1.0
3V41x0
3V44x0 0-5692 1 -4xx 1.0
5V41x0
5VA4x0 0-5692 1 -4xx 1.0
7V41x0
7.5-10HP 7V42x0 0-56921-Axx 10
10V41x0
410V42x0 0-5692 1 -4xx 1.0
15V41x0
15V42x0 0-56921 -4xx 2.0
20V41x0
15 - 25 HP 20V42x0 0-56921 -4xx 2.0
25G41x0
25G42x0 0-56921 -4xx 2.0
25 - 5S0HP 30R41x0 413338-5AU 3.0
50R41x0 413338-5AU Contact
40-100 HP 75R41x0 413338-5AU Reliance
100 - 150 HP 125R41x0 413338-5AU 4.0
NOTE: /f you are replacing the Regulator board in order to upgrade your system to Version 4, and you have
purchased the Configuration Executive (CE3000) software, save your configuration to a personal computer
before you begin the installation procedure if you have not donethis previously. Refer to the CE3000
instruction manual (D2-3303) for this procedure.