-
� Safety Precautions about TD-W103
.
Since these parts are heating parts,
make sure that nothing of other parts
and wires don't contact with them.
(Heat sink, IC904, R941, R942,
R943, R944, R962,Q906}
Fasten the power cord to the board by
the soldered terminal of the cord.
��H.f--t--ff+il---t--Arrange wires and signal windings
Fuse
Fig. 2-1
U
Version
(-------------,
______
Fuse
Fasten the power cord to the board by
the soldered terminal of the cord.
Fig. 2-2
TD-W103
Bind wires and fasten them at the point shown
in the figure aside from the mechanism drive
section.
as shown in the figure, and put them
apart from the primary circuit .
'
I
'
I
'
I
_)
A/B/C/E/G/,